We changed domain for our shop to store.aprbrother.com
We changed domain for our shop to store.aprbrother.com The URL of blog is changed to https://store.aprbrother.com/press
Details
Create a custom iBeacon using nRF52 and ABSniffer USB Dongle
The ABSniffer 528 USB dongle is a ready-to-use nRF52 dongle with a very compact form factor. Its intended use is as a low-cost BLE sniffer that can sniff the advertisements of nearby devices. It features an NRF52832 chipset and a SiLabs CP2104 USB-to-serial converter. This article shows how to write a custom iBeacon firmware for the…
DetailsSiri HomeKit Controlled ESP8266 Lock
How to build a HomeKit / Siri controlled election lock with ESPea and Relay shield. It’s a cheap project for smart lock. I built a custom HomeKit / Siri controlled election lock recently. It need ESP8266/NodeMCU, Raspberry PI and a Electric Lock 12V DC. See more information at the instructable
Details
New Products: More Shields For ESPea
BMP280 shield for ESPea. The BMP280 sensor can measure barometric pressure and temperature with very good accuracy. This shield is good match with ESPea, ESPea32. It also has nice size. Buy Link ESPea Relay Shield for ESPea. This is the ESPea Relay Shield, an add-on board that allows your ESPea to control higher voltage and current loads…
Details
New Product: OLED Shield For ESPea
128×64 pixels OLED Shield with I2C. It adds a 128×64 monochrome OLED to ESPea main board. The OLED uses only the two I2C pins on the ESPea, and you can pretty much stack it with ESPea, even ones that use I2C since that is a shared bus. Buy Link. Prototype Shield For ESPea is also…
Details
How to build a rainbow lamp with BLEPad
This Instructable shows how to build a simple rainbow lamp with BLE controled using BLEPad and WS2812B ring. The BLEPad is an Arduino compatible microcontroller development board based on the ATmega32U4 with BLE built in. Read more at Instructables.
DetailsExample Codes For Wireless iBeacon Receiver
We added a repository for MQTT client example code. These example can work with our product Wireless iBeacon Receiver. Currently java and python examples are available. Please check the wiki for more information.
DetailsNew example code for Cactus Micro from IOTLink
The following example in C uses the REST interface with a secure SSL configuration to exchange AP configuration with the onboard ESP8266. The board is a Cactus Rev 2. The sketch updates the status every 60 seconds in the IoTLink dashboard. click on Learn More, then Examples, there are examples for Cactus rev 2 using…
Details
New Product Available: ESPea Dev Board
ESPea is a new Wi-Fi development board from AprilBrother technologies. It uses the ESP8266EX chipset as the main micro-controller and supports the Arduino environment. At the ESPea’s heart is an ESP8266 WiFi microcontroller clocked at 80 MHz and at 3.3V logic. This microcontroller contains a Tensilica chip core as well as a full WiFi stack.…
Details
New Product: BLEPad available
BLEPad – The BLEPad is an Arduino compatible microcontroller development board based on the ATmega32U4 IC with BLE, built in. You can choose board type LilyPad Arduino USB from Arduino IDE to start programming. It’s the easiest way to get BLE in your project!